The Parallel Designs Cobra 427 Demonstrator was built on a budget,an excercise to prove what it would cost using 90% of the Doner BMW E34 parts,with a stunning result of £12,000

we used a BMW E34 525i 1995, (single vanos ) with a power output of just under 200bhp, the whole car weighed at just 940kg, This perticular engine was from a Motorsport and had benefited from a superchip, thus increasing the power output to 245bhp, the beauty of this engine is that it will give you a maximum of 7000rpm with a contstant torque curve figure,

We supply you with a British colour coded wiring Harness for your Cobra, if you are confident you can configure the BMW engine loom to the cobra loom yourself (with instructions supplied), but for an additional cost you can leave the heartache to Parallel Designs , as you can see in the picture below, we also keep the Diagnostic plug for scanning future engine & ABS faults,

For an additional cost We can supply you with the Aluminium air-scoop at the front nose with the bespoke radiator so that the car looks Aluminium ,

The Radiator comes complete with all studs welded to bolt on the 15''fan, also ready to bolt on the radiator fan switch,( with the temprature to match the BMW engine,) also the temprature transmitter to make your temprature Gauge work, and finally the brackets welded to fit into the chassis,

The Doner supplies the Brake Master cylinder and Servo to fit the Parallel Designs Pedal box,and also bracketry to make it remote and fit under the wheel arch, ( the above SVA bottle and hoses are supplied by Car Builder Solutions

we have fitted the ABS Distribution Valve on the opposite side of the Master Cylinder front wheel arch , it's an area were you can fit this delicate unit without future damage occuring,

we can supply you with a be-spoke system for your BMW Cobra, we will need to use the Doner Catalitic Convertor and then we can make a twin system for the both side pipes, we will make provision for the Oxygen Sensor to be bolted back into the new system